Digital manual for setting up a splicing tent!

Important before you begin!

Caution! Treatment with impregnation spray is necessary for a fully waterproof tent. Do not use the tent during thunderstorms or storms and always keep it away from open flames. The tent is not fire retardant. The accessories include three tent pegs and three cords. These allow you to secure each side of the tent securely via the loop in the middle, which you fix into the ground. Be sure to lightly tighten the female screw of the hinge each time you use it. Re-treat the tent with waterproofing agent after a few uses to maintain protection.

Step 1

Order your Splicing tent and impregnation spray here. Remove the tent from the bag and place it on the ground.

Step 2

Check that all the zippers of the tent are closed before you begin. Lay the tent flat on the ground in a folded bundle, as shown in the picture.

Step 3

Pull apart the four metal knobs you see in the picture of step 2. Next, pull the black loop of the roof. This will cause the roof of the tent to unfold. As you see in the photo.

Step 4

Once the roof is formed, carefully lift the sides. Find the loops on each side and pull them out to form the four sides of the tent.

Step 5

The tent is now upright. Check that all corners are secure and that the tent is fully unfolded. Make sure all panels and joints are properly attached. If the tent is on soft ground, use the pegs provided to secure the corners.

Step 6

To extend the life of your tent, spray it with an impregnation spray. This helps to make the tent waterproof and protect it from saturation by moisture. Use the spray according to the instructions on the package to keep your tent in good condition.

Safety Tips

Do not use the tent during thunderstorms or storms. Keep it away from open flames. The tent is not fire retardant! Use at your own risk! The manufacturer assumes no liability for improper use. Nor for damage caused by using the tent. Please note that the female screw of the hinge is slightly tightened each time. Re-treat the tent with waterproofing agent after a few uses.